Home › Services › AC installation
Problem guideAC installation: what a proper job includes
An air-conditioning installation is a design and commissioning job, not just equipment. The right capacity, a matched indoor coil, a correctly sized and sealed duct system, a proper line set, and a verified charge and airflow determine whether the system delivers comfort and efficiency. A cheap installation that skips commissioning costs more over its life.
- Independent referral service
- No charge to homeowners
- One contractor receives your request
- No ratings or paid placements
Request a callback
Describe the symptom and your ZIP. One contractor receives it if one serves your ZIP.
Symptoms
- The old system never kept up, even when it was new.
- Rooms above or far from the air handler are always warmer.
- The ductwork is original to the house and visibly leaky or undersized.
- The outdoor unit is noisy or the indoor coil is leaking.
- A contractor quotes a replacement without measuring the house or the ducts.
Safe checks you can do
- Ask for a load calculation (Manual J or equivalent) or a documented engineering review, not a rule-of-thumb size.
- Ask whether the duct system will be tested and sealed, and whether the static pressure will be measured.
- Ask for the model numbers of the indoor and outdoor units and confirmation that they are a matched system.
- Ask what is included: line set, drain pan, float switch, thermostat, permit, haul-away, commissioning report.
- Ask for the warranty terms for parts and labor in writing.
- Confirm the contractor's license number and verify it yourself in the DBPR lookup before signing.
Likely causes
- Oversizing — A system that is too large cools quickly and leaves the house humid. It also cycles more.
- Undersized ducts — A good system on restrictive ducts cannot deliver its rated airflow.
- Poor commissioning — A charge that is not verified by superheat and subcooling, or airflow that is not measured, leaves performance on the table.
- Cheap line set or drain work — Reused or poorly routed lines and drains cause leaks and callbacks.
- No permit — A permitted job protects the homeowner and the resale value. Ask for the permit number.
What a repair involves
A proper installation starts with a load calculation and a duct assessment, includes a matched system and a clean line set, and ends with measured airflow, verified charge, a drain test and a written commissioning record. The contractor should walk you through the thermostat and the filter schedule before leaving.
Typical South Florida cost ranges
| Work | Published typical range | Notes |
|---|---|---|
| Full system replacement | $4,000–$8,000+ | Published South Florida ranges; home size, efficiency, duct work and line-set condition drive the number. |
| Duct replacement or major sealing | $1,500–$5,000+ | Depends on the number of runs, attic access and insulation. |
Source: AC Service Pro (South Florida contractor cost guide), published 2026-07-13; Koala Coolin (South Florida contractor cost guide), published 2026-07-12. Both guides publish installed price ranges for South Florida; neither states its sample size. These are ranges, not quotes. The contractor sets the actual price after inspecting the system, and you approve it before work begins. See the cost guide methodology.
Seasonal context
Shoulder months are the best time to replace: scheduling is easier, and the house is not dependent on the system during the work. A summer failure forces a rushed decision.
Where to go next
Find your city · Cost guide methodology · What to check before you call · All services
How a request is handled
Your request includes the symptom, your ZIP code, how soon you need help and the best time to reach you. If a participating contractor covers your ZIP, that one contractor receives it.
If no participating contractor covers the ZIP yet, we tell you and your request is not shared with anyone else.
We do not promise an arrival time. The contractor confirms availability with you directly.
Questions
How long does an installation take?
A straightforward replacement is often one day; a job with duct work or electrical upgrades can take several. Ask for a written schedule.
Do I need a permit?
Florida law requires permits for much HVAC work. Ask the contractor and confirm with your county or city building department.
What is a matched system?
An indoor coil and outdoor unit designed and rated together. A mismatch can reduce capacity, efficiency and warranty coverage.
Request a callback
One contractor, if one serves your ZIP. No charge to you.
Request a callback
Tell us what is wrong. If a participating contractor serves your ZIP code, your request goes to that one contractor.